Heras HMD230 - Page 5

EN – Translation of the original user manual - 2.1 | 2019
5
6.3.2 Connecting the ISK system ................................................................... 56
6.3.3 Connecting a photocell ......................................................................... 56
6.3.4 Wiring diagram for the inputs on the terminal block ................................. 57
6.3.5 Incremental encoder ............................................................................ 57
6.4 RELAY OUTPUT CONNECTIONS..................................................................... 58
6.4.1 Relay output with 24 V
DC
....................................................................... 59
6.4.2 Relay output with 230 V
DC
..................................................................... 60
6.5 CONNECTING THE RADIO-FREQUENCY RECEIVER ........................................... 60
7 PROGRAMMING AND SETTINGS ................................................................... 62
7.1 CHANGING THE DIRECTION OF ROTATION OF THE DRIVE ................................ 62
7.2 PROGRAMMING THE MOVING ANTI-CRUSHING SAFETY PROTECTION DEVICES
(ISK) 62
7.2.1 Connecting a JCM Radio band system ..................................................... 62
7.2.2 Setting JCM No-Touch System .............................................................. 64
7.3 LEARNING THE END POSITIONS OF THE GATE ................................................ 65
7.3.1 Marker plate ........................................................................................ 67
7.4 CHANGING THE OPERATING MODE: DEAD MAN'S OPERATION / AUTOMATIC MODE
68
7.5 SETTING A PHOTOCELL ............................................................................... 68
7.6 CONNECTING A FLASHING LIGHT ................................................................. 69
7.7 SETTING A LAMP (YARD LIGHTING) .............................................................. 69
7.8 PROGRAMMING SERVICE INTERVALS ............................................................ 70
7.8.1 Cycle counter ...................................................................................... 70
7.8.2 Motor runtime ..................................................................................... 71
7.8.3 Maintenance interval ............................................................................ 71
7.8.4 Setting the maintenance message on a flash light .................................... 71
7.8.5 Maintenance message on a relay output ................................................. 72
7.8.6 Reset service ....................................................................................... 73
7.9 SETTING THE EMERGENCY SITUATION FUNCTION .......................................... 73
7.10 SETTING THE TRAFFIC LIGHT ........................................................................... 74
7.11 TIMER-CONTROLLED GATE MOVEMENTS .................................................... 75
7.11.1 Setting automatic closing ...................................................................... 75
7.11.2 Time to close from Part OPEN position .................................................... 76
7.11.3 Time to close the gate from interim positions .......................................... 76
7.11.4 Setting a short closing time ................................................................... 77
7.12 DISABLE CALENDAR FUNCTION ................................................................ 77
7.13 DISABLE AUTOMATIC CLOSING TIMER ....................................................... 77
7.14 OPTIONAL FUNCTIONS ON IN5 AND IN6 ..................................................... 78
7.15 ADDITIONAL ELECTRIC BRAKE .................................................................. 78
7.16 ADDITIONAL OPTIONS FOR REL4 AND REL5 ................................................ 79
7.17 SAVING PARAMETERS TO THE MEMORY...................................................... 80
7.17.1 Saving the parameter settings ............................................................... 80
7.17.2 Restoring parameter settings ................................................................ 80
7.18 SAVING PARAMETERS TO CHIPCARD ......................................................... 80
7.18.1 Saving the parameter settings to card .................................................... 81
7.18.2 Reading the parameter settings from the card ......................................... 81