EN – Translation of the original user manual - 2.1 | 2019
• Menu: "Service Menu", "Enter passw.": enter the password.
• Menu: „Settings“, „Spec.parameter“, „Cycles to Service“: set to „zz“
The input "zz" defines a number of cycles (in 1000 cycles) that the gate is "open"
and again "closed". Each time the end position "CLOSED" is reached, the counter
is incremented. When the counter reaches the preset value of "zz", the control
activates the maintenance message. The value "zz" is the maximum number of
gate cycles (in 1000 cycles) (CLOSED, OPEN, CLOSED) to the service request. The
adjustable values mean:
0 = no maintenance notification after number of cycles
25 = 25.000 complete movements OPEN and CLOSE
7.8.2 Motor runtime
Maintenance after the completed engine running time (in hours) is possible with
the help of this adjustable parameter. On delivery, this option is not used and the
value is preset with 0 hours. The maintenance message can be set as follows:
• Menu: "Service Menu", "Enter passw.": enter the password.
• Menu: „Settings“, „Spec.parameter“, „RuntimeToService“: set to
a value in number of hours
7.8.3 Maintenance interval
For regular maintenance of the gate, it is the intention to define a maintenance
message after a certain period of time (number of months). When the defined
time is reached or exceeded, the "Maintenance Necessary" event is activated in
the control system. On delivery, this option is not used and the value is preset
with 0 hours. The maintenance message can be set as follows:
• Menu: "Service Menu", "Enter passw.": enter the password.
• Menu: „Settings“, „Spec.parameter“, „Serv.Interv. M“: set to „mm“
The input "mm" defines the number of months until the maintenance message.
The value 0 means: no maintenance message after time. The maximum value
that can be set is 60, which corresponds to 5 years.
7.8.4 Setting the maintenance message on a flash light
A maintenance message from the control can activate an additional action of the
flashing light via a menu entry. As soon as a condition for the maintenance
To Next Page
