Hercules HE35 - User Manual

Questions and Answers

S
Sarah OwensAug 12, 2025
Why won't my Hercules HE35 start?
- M
  Michael AndersonAug 12, 2025
  Several factors can prevent your Hercules Rotary Hammer from starting. First, ensure the power cord is properly connected. Second, verify that the outlet has power; if not, check the circuit breaker, ensuring it's the correct capacity and not overloaded. Third, if your tool has a thermal reset breaker, turn it off, let it cool, and then press the reset button. Lastly, internal damage or wear may be the cause, in which case you should have a technician service the tool.
A
Angela NorrisAug 19, 2025
What to do if my Hercules Rotary Hammer is overheating?
- A
  Amy GardnerAug 19, 2025
  If your Hercules Rotary Hammer is overheating, there are several potential causes. First, avoid forcing the tool to work too fast, allow it to operate at its own pace. Second, check and correct the accessory alignment. Third, ensure cutting accessories are sharp and replace them if dull or damaged. Fourth, clear any blockages from the motor housing vents, using compressed air while wearing safety goggles and a dust mask/respirator. Finally, eliminate the use of extension cords, or if necessary, use a proper diameter extension cord.
N
Nathan PerkinsAug 27, 2025
Why is my Hercules Rotary Hammer's performance decreasing over time?
- P
  powelljonathanAug 27, 2025
  A decline in your Hercules Rotary Hammer's performance could stem from a few issues. Make sure your cutting accessories are sharp and replace them when needed. Another potential reason could be worn or damaged carbon brushes, which should be replaced by a qualified technician.
R
Rose ConnerSep 3, 2025
Why is my Hercules HE35 making excessive noise?
- C
  Christopher BennettSep 3, 2025
  Excessive noise or rattling in your Hercules Rotary Hammer usually indicates internal damage or wear, such as with the carbon brushes or bearings. In such cases, have a technician service the tool.