Page 6 R":09$STCES3%0UF$D9E"CDH07%$3D$0S3%%0*+...+.VV+),W,M Item 56845
OPERATING INSTRUCTIONS
08$3#09T$0'>5?8'0?!]J85=>501=R'5j0
?>RJ8!=5?J>0D$S9E"C03909T$0\$YECCECY0"X0
9TED0;3CF3%0ECS%F#ECY03%%09$490FC#$:0
DF\T$3#ECYD09T$:$EC0\$X":$0D$90F70":0FD$0"X09TED0
7:"#FS9M
Tool Set Up
5J0]8'N'>501'8?JI10?>kI8j0R8J!0
=^^?2'>5=O0J]'8=5?J>A0
8$%$3D$09T$05:EYY$:03C#0FC7%FY09T$09""%0
X:";0E9D0$%$S9:ES3%0"F9%$90\$X":$03#GFD9ECY0
9T$09""%0":0ECD93%%ECY03SS$DD":E$DM
Adjusting the Auxiliary Handle
The Auxiliary Handle can be placed
in a variety of positions.
To adjust the Auxiliary Handle, turn the Handle
counterclockwise to loosen the band. Slide the
Handle to the desired position then turn the
Handle clockwise to secure it in place.
Adjusting the Functions
^TED$%0=#GFD9;$C9
!"#$01$%$S9":
^TED$%0=#GFD9;$C9
&3;;$:
&3;;$:-
2:E%%
REYF:$0=
Adjust the Mode Selector to the desired function before
using the Rotary Hammer. Rotate the Mode Selector until
it clicks in place with the desired function at the Indicator.
>J5?^'A Move the Mode Selector only when the
Motor is stopped. Attempting to move the Mode
Selector while the Motor is engaged will result in
abrupt bit rotation and can cause property damage.
>J5?^'A When moving the Mode Selector,
make sure it clicks into the desired position. If
not actively engaged, the Mode Selector could
slip out of position resulting in tool damage.
5"0&3;;$:-2:E%%A Rotate the Mode Selector to
the Hammer/Drill setting. The Rotary Hammer
will revolve and hammer when powered.
5"0^TED$%A Rotate the Mode Selector to the Hammer
Setting. The Rotary Hammer will hammer when powered.
5"0=#GFD90^TED$%0=CY%$A Rotate the Mode Selector to the
Adjust Chisel Setting.
You can now rotate the bit to the desired angle for
chiseling. When finished adjusting the bit, rotate the
Mode Selector to the Hammer Setting to begin chiseling.
Work Piece and Work Area Set Up
1. Designate a work area that is clean and well-
lit. The work area must not allow access by
children or pets to prevent distraction and injury.
2. Route the power cord along a safe route to reach
the work area without creating a tripping hazard or
exposing the power cord to possible damage. The
power cord must reach the work area with enough
extra length to allow free movement while working.
3. Secure loose work pieces using a vise or clamps
(not included) to prevent movement while working.
4. There must not be objects, such as utility lines,
nearby that will present a hazard while working.
5. Protect power cord from crushing, abrasion,
and scraping by broken rock or concrete.
6. Keep power cord away from moving machines.
To Next Page
Loading...