Why does my HERKULES HSG 190 D Welding System produce a very poor weld?
If your HERKULES Welding System produces a very poor weld, first check the current and feed settings according to section 6.1.1/6.1.2. Also, verify there is enough gas and check the filling pressure of the gas bottle, as described in section 6.1.3.
What to do if the feed roller turns, but does not feed any wire in HERKULES HSG 190 D?
If the feed roller of your HERKULES Welding System turns but does not feed any wire, consider the following: * Check the roller pressure setting. * Check if the roller brake is set too firmly. * Clean or replace the feed roller if it is dirty or damaged. * Inspect the wire guide jacket for damage. * Clean or replace the contact tube if it's the wrong size, dirty, or worn. * Release the welding wire if it's welded to the gas nozzle or contact tube.
What to do if HERKULES HSG 190 D Welding System overheats and stops working?
If your HERKULES Welding System stops working after extended use and the thermostat control light is on, it likely overheated. Allow the set to cool down for at least 20–30 minutes.
How to fix a HERKULES Welding System when the feed roller does not turn?
If the feed roller of your HERKULES Welding System does not turn, check that the power supply is connected and also check that the wire feed controller is not set to 0.
Details the layout of the welding machine and its components.
Details the items included in the delivery package and checks for completeness.
Information on electrical connection, interference, and filters.
User's responsibility for proper installation and use.
Measures for emissions reduction, focusing on main current supply.
Advises individuals with pacemakers about proximity to welding equipment.
Instructions for installing castors, guide rollers, and welding screen.
Details on connecting the gas supply, including gas types and bottle mounting.
Instructions for connecting to the mains supply, including voltage settings.
Guide on fitting the wire spool and its capacity.
Guidance on setting welding current, wire feed speed, and gas delivery rate.
Instructions for electrical connections, including mains and earth terminal.
Steps for performing the welding process.
Information on safety features like the thermostat.
Instructions on how to clean the welding set and its components.
Note that no internal maintenance is required.
Information required when ordering spare parts.
General| Welding process | MIG/MAG |
|---|---|
| Welding current range | 30 - 190 A |
| Duty cycle | 60% at 190 A |
| Wire diameter | 0.6 - 1.0 mm |
| Power Supply | 3-phase |
To Next Page
