OPERATIONS GUIDE
1 BATTERY
When inserting the battery, please align the push-release spring on the battery to
the battery release button on to the massager, then insert the battery(Figure 1).
If you wish to remove the battery, press the battery release button, and pull the
battery away from the massager at the same time. (Figure 2).
Figure 1 Figure 2
Figure 3
Figure 4
2 POWER ON/OFF SWITCH
Power switch is located on the bottom of the battery unit. To power on the massager,
slide the power switch to the on position. Prior to removing the battery for storage
or travel, always turn the massager off by sliding the power switch to the off position.
3 BATTERY INDICATOR
The Battery Indicator enables user to quickly identify how much power is remaining.
When display is showing 99, the battery is completely full (this is a 2-digit display, so
99 is the maximum value). Recharge the battery with the supplied power adapter
when battery drops to 20 or below.
Full
Medium
Low
4 GEAR INDICATOR
The number on the left side of the screen represents the current gear setting. For 01
gear, pulse frequency is 1200spm (30PPM). BFGun stealth incorporates an electronic
controlled 6-speed gear box. With each increase in gear, the speed is increased by
400spm (about 7PPM). Highest gear is 6 with a pulse frequency of 3200spm (53PPM).
To ensure safety and prevent injury, BFGun is programmed with built-in safety
timer to limit each percussive therapy session to 10 minutes. And to ensure
long-term performance of the high-speed motor, we recommend to allow the
massager to cool-down for 15 minutes after 3 consecutive 10-minute uses.
Power OffPower On
Figure 5
Increase Speed
(each gear
increases the speed by ~400spm)
Decrease Speed
(each gear
decreases the speed by ~400spm)
*Note: powering on the unit does not start the massager. To start the massager,
*press the “+” button to actuate.
*PPM = Percussion Per Minute.
To Next Page
Loading...