Heroproof BFGUN STEALTH - Massage Head Assembly; Device Charging; Safety and Maintenance; Safety Instructions

Figure 6
Charging-Red LED on
Figure 7
Fully Charged-Green LED on
5 QUICK ASSEMBLY MASSAGE HEAD SYSTEM
With the massager off, pull the attachment away from the head to remove. To attach,
align and press the attachment into the massage head.
Prior to charging, turn off the massager by sliding the power switch to the off position.
Never charge the unit while it is in-use.
Battery may remain inserted in the massager while charging. Use only the provided
charging adapter.
Connect the charging plug into the charging port on the bottom of the battery. Red
LED on the charging adapter indicates charging is in progress (full-charge requires
approximately 1.5 ~ 2.0 hours). When fully charged, the LED turns to green.
6 CHARGING
SAET INSTRUCTIONS:
TO REDUCE THE RISK OF ELECTRIC SHOCK, FIRE AND PERSONAL INJURY,
THIS PRODUCT MUST BE USED IN ACCORDANCE WITH THE FOLLOWING
INSTRUCTIONS.
Only allowed for adults.
This device cannot directly massage the surface of the skin to avoid injury to the skin,
the massage area should be worn after wearing dry and clean clothes or a clean and
dry towel, you need to gently press and move, the massage time of the same part
can not exceed 60s.
Use high speed and high pressure only for soft tissue parts of the body without
causing pain and discomfort, do not use high speed and high pressure on the head
and any bone parts of the body.
According to the massage needs of different parts, please choose the right massage
head.
Frequent use of high-speed high pressure to apply pressure on the same part will
cause abrasions, if you feel painful and uncomfortable, please stop using immediately.
Finger, hair or any part of the body, please keep away from the telescopic rod of the
device and the heat dissipation hole of the motor to prevent from pinching injury.
Do not place anything in the heat sink of the motor.
The equipment should not be diffused into the water, never let the water from the
motor cooling hole into the equipment.
Do not discard and misuse this device.
Only use the original charger to charge.
Carefully check your device and battery before each use.
Do not make any private modifications to the equipment.
Do not run the device and charge the device in an unmanned state.
Do not stay in the water, keep the machine away from liquids and heat sources, to
ensure the motor cooling holes are free of dust and debris.
Do not remove the screws by yourself.
Turn off the device after one hour of operation and use it after rest for half an hour.
Remove the charger from the battery after charging, and do not use the device
during charging.
The use of this device for the injured part of the body is prohibited without consulting
the doctor.
MAINTENANCE:
Wipe the surface of the device with a slightly damp towel and dry with a soft cloth.
When storing or traveling for a long time, separate the device from the battery and
place it in the device's original case.
ARNING:
G EA R 1 G EA R 2 G EA R 3 G EA R 4 G EA R 5 G EA R 6
SPM
St r o k e Pe r
Mi n u t e
12 00
1600 2 000 2 4 00 2 800 3 2 00
PPM
Pe r c u s s i o n Pe r
Mi n u t e
2 0 2 6 3 3 4 0 4 6 53