P.08
REMOVING THE COLLECTED WATER
Operating Instructions
When the water tank is full, the water is full of lights flashing, and then
automatically stop, at this time must empty the water tank. And place the
water tank correctly.
Empty the Water Tank
1
3
2
4
Put your hand into the groove at the
bottom of the water tank, gently pull
out the water tank, and pay attention
to supporting the water tank.
The Arrow points to a water tank
outlet.
Invert the tank and empty the water
Put the tank back in place
Note:
● Do not remove the floater in the water tank. If the floater of the water tank is removed, the
water senser will not be able to normally sense the water level, and the water will overflow
from the water tank when the water is full.
●If the tank is dirty, only can be used in cold or warm water wash, do not use detergent, steel
wool, chemical processing dust cloth, gasoline, benzene, thinner or other solvent treatment,
other wise it may cause damage to the tank Water Leakage.
● When the water tank is put in, the water tank is pressed tightly with both hands. If the
water tank is not placed, the water sensor will still be started, and the dehumidifier will not
be able to run.
To Next Page
Loading...