lag manual
www.hex.haus
@hex.haus.hex
info@hex.haus
POWER
HEX can be powered via the USB C socket (10) using a USB power adapter/power bank.
1. Touch pads | 2. Gain | 3. Rate | 4. Spread | 5. Feed | 6. Push button |
7. Header pins | 8. 3,5 mm input | 9. 3,5 mm output | 10. USB C power port |
FEATURES
PERFORM
Lag is a real-time sound processing device. The signal sent through the left jack input (8), goes through
the GAIN (2) stage and is fed into the circular buffer delay line.
There are four potentiometers dedicated to sound manipulation. GAIN (2), RATE (3), SPREAD (4) and
FEED (5) settings can be adjusted to turn your sounds into thick drones, bit crushed chaos, pitch shifted
copies, junglist stutter, etc. RATE controls the sampling speed and overall delay time, while SPREAD is
used to adjust the separation between the read & write “tape heads” within the circular buffer. The FEED
potentiometer can also push the device to self-oscillation mode, enabling standalone usage.
Touch the golden touch pads (1) to additionally manipulate the DELAY and SPREAD parameters for manual
vibrato-like effects and expressive sound design.
Push button (6) can be used to achieve the freeze/stutter effect. The stereo output jack (9) outputs two
versions of the signal - 50% and 100% wet.
SECONDARY MODE
Lag also has a pitch-shifter mode which can be accessed by turning the SPREAD potentiometer fully
clockwise and pressing the push button. In this setting, RATE controls the sampling speed and SPREAD
adjusts the pitch-shifting frequency. FEED still controls the feedback, producing granular-like pitch shifted
swells.
I / O
There is a triple header row next to the input jack for interfacing with external control voltages. The top pin
is connected to GND, the middle to SPREAD and the bottom to RATE potentiometer. Both SPREAD and RATE
expect a unipolar signal 0-5V.
Put HEX next to a wall, mark dots where the * show. Hammer the 3 nails into the marked spots and
voilà, you’ve built yourself an improvised HEX mount.
1. Read these instructions. 2. Keep these instructions. 3. Heed all warnings. 4. Follow all instructions. 5. Do not use this apparatus near water.
6. Clean only with dry cloth. 7. Install in accordance with the manufacturer’s instructions. 8. Do not install near any heat sources such as radiators,
heat registers, stoves, or other apparatus (including amplifiers) that produce heat. 9. Touch pads on the instrument are able to output a low
current, therefore the device is unsuitable for individuals with implantable cardioverter-defibrillators (ICD), pacemakers, heart diseases and
small children. 11. Power the device only using 5-volt USB C power adapters and cables. 12. Protect the power cable from being walked on or
pinched particularly at plugs and connectors at the point where they exit from the device.13. When interfacing with other devices, follow the
manual and check external devices input and output voltage (CV and audio signals). 14. Unplug this device during lightning storms or when
unused for long periods of time. 15. When replacing parts, disconnect the device from power sources and unplug all attached cables. Contact the
manufacturer for information about recommended substitute part selection. When repairs are undertaken by anyone but the manufacturer, the
latter is absolved of all responsibilities. 16. Correct disposal of this product: this product must not be disposed of with household waste, according
to the WEEE Directive (2012/19/EU) and your national law. This product should be taken to a collection centre licensed for the recycling of waste
electrical and electronic equipment (EEE). The mishandling of this type of waste could have a possible negative impact on the environment and
human health due to potentially hazardous substances that are generally associated with EEE. At the same time, your cooperation in the correct
disposal of this product will contribute to the efficient use of natural resources. For more information about where you can take your waste
equipment for recycling, please contact your local city office, or your household waste collection service. 17. Do not place naked flame sources,
such as lighted candles, on the device. 18. This apparatus may be used in tropical and moderate climates up to 45°C. 19. Children must use this
product under adult supervision.
DISCLAIMER and WARNINGS
*
*
*
1
1
GAIN RATE
SPREAD
FEED
1
2
4
5
3
6
10
8
9
1
7
To Next Page
Need help?
General