dCC Jogbox – User Manual
When removing covers or parts (except parts removable by hand), live parts can be
uncovered and touched. Pay attention to all contacts.
In case specific maintenance or repair works must be carried out on the open machine
with power switched on, this work should be undertaken by authorized personnel
only.
Make sure to use exclusively fuses of the specified type and nominal current.
Basically, all international and national safety standards have to be observed.
Repair operations are to be carried out by authorized personnel of Hexagon
Metrology GmbH only. The warranty expires in the event of unauthorized tampering
with the System.
If the safety operation of the system cannot be ensured, the machine must be put to
a standstill and to be secured against unintended use.
In this case, please contact Hexagon
To Next Page
Loading...