18
www.hglrc.com
15.OSD settings
1. Click the OSD Settings, according to the need to choose, drag
the OSD schematic diagram of the parameters can be adjusted.
16. LED settings
1.LED function buttons:
Short press to switch colors.
Press and hold for 3 seconds to enter the blinking mode switch
(LED status light is always on)
2.Blinking mode:
Steady / Fast Flash / Breathing Light / Colorful Slow Flash
3.LED light can be controlled via CH5(AUX1) of transmitter with
Channel_Forwarding enabled.
Click enter
：
resource servo 1 A08
SAVE
To Next Page
Loading...
Need help?
General
