Need help?Do you have a question about the HGLRC Zeus35 and is the answer not in the manual?
Procedure for calibrating the accelerometer by placing the board on a leveled surface and performing rotations.
URAT1 for VTX transmission and URAT2 for receiver (SBUS/iBUS/DSM/CRSF/R9MM) connections.
Procedure to select the aircraft model (e.g., Quad X) and configure motor steering.
Select the appropriate ESC protocol, with DSHOT600 as a universal option.
Configure battery voltage and current meter settings, including scale and offset values.
Configure the receiver by setting up the serial port, typically UART2, in the Betaflight Ports tab.
Configure the flight controller for SBUS receiver input using the serial-based receiver option.
Configure the flight controller for PPM receiver input using the PPM RX input option.
Configure the flight controller for DSMX receiver input using the SPEKTRUM2048 serial provider.
Connect the VTX using its serial port and configure OSD smart audio for video transmission.
Use the Betaflight OSD menu to adjust VTX settings like frequency band, channel, and power.
Verify the remote control signal by checking the output signals for channels and auxiliary functions.
Configure flight modes by assigning transmitter switches to different operational modes.
Customize OSD display by selecting and arranging elements like voltage, flight mode, and warnings.
Configure LED support, strip wiring mode, and assign functions/colors to LEDs.
Important cautions regarding polarity, power disconnection, and refresh rate to prevent damage.
Information on handling product issues, repairs, and contacting customer service for domestic and overseas users.
Troubleshooting common issues like OSD garbling, self-test failures, and spinning problems.
General| Max Current | 35A |
|---|---|
| Peak Current | 40A |
| Input Voltage | 2-6S |
| Firmware | BLHeli-S |
| Mounting Hole | M3 |
To Next Page
