Hiboy DK1 - Charging

5
4
4. Charging
Open the rubber plug Insert the charging plug in
Fill and fix the rubber plug
after the charging
Note:
• Hiboy electric dirt bike will be fully charged when the LED light on the charger changes from red （charging） to green.
When the battery is fully charged, please STOP CHARGING and unplug the unit.
• Do not charge when there is excessive odour/ heat, leakage or physical damage.
• Do not connect the charger if the charging port is wet. Keep your charging environment clean and dry at all times.
• If the charging port is damp or has any liquid on it, do not charge your E-Bike.
• In order for the battery to operate at maximum efficiency, avoid charging your E-Bike in extremely hot or extremely cold
environments.
• Use only the battery and charging cable provided to you by HIBOY. If a replacement is needed, please contact HIBOY directly.
• Use caution when charging. Charger should be operated by an adult.
• Always disconnect from the charger prior.
Up aluminum assembly
Put the handlebar assembly on the up
aluminum assembly, move it symmetrically
and adjust it to the right angle for your
riding.
Put on the up
aluminum assembly, then put
on 4pcs M8*20mm cylindrical head socket
head cap screws.
Tighten the screws with a 6mm socket
head wrench.
Down aluminum assembly
Handlebar assembly
M8*L20mm screws with
hexagon socket head cap
1
2
3