EasyManua.ls Logo

HiBREW H7A - Page 10

HiBREW H7A
19 pages
Print Icon
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
EN
Sleep state: the machine will automatically enter the sleep state when there is no operation for 15
minutes in the standby state. In the sleep state, press any key and turn the knob to activate the machine
to re-enter the preheating state.
Suggestion: we suggest that you preheat the appliance before brewing the coffee, including
funnel, filter screen and cup, so that the coffee will not be affected by the cold appliance. The
specific method is to put the filter screen into the funnel, screw the funnel into the funnel
support, put in the cup, press Oor 3, and then brew the coffee after the machine stops.
Special attention: the steam and coffee functions of this machine can be used at the same time. Please
pay attention to the function selection when operating the machine to avoid personal injury due to
wrong operation.
2.Ground Coffee Beans
This product has a coffee bean grinding function, before using this function, please make sure that
all devices are installed in accordance with the requirements. The details are as follows:
(2)
Figure 1: install cutter head 2 and tighten it
clockwise; then install bean box I and screw it as
shown in Figure 2
Figure 2: align the positions in red circles in the figure, and press it
down, rotate it clockwise and install it into the machine.
There•re markings to show the coffee coarseness on bean box, see Figure 3. To make the coffee
coarseness you prefer, make sure the coffee coarseness setting you want on bean box is aligned
with the mark position on the top cover (as shown in Figure 4).
FASTER
EXTRACTION
MEDIUM
SLOWER
EXTRACTION
COARSE
30
FINE
25 20 15 10
5
Figure 3: from O to 30, coffee power is from fine to
coarse. Bigger number for coarser coffee powder.
(Figure 4)
I.After ensuring that the device is installed in place and the bean box indication on the panel changes
from red to off, it indicates that the bean grinder is ready and can be used normally.
2. Add an appropriate amount of coffee beans into the bean box. In order to avoid moisture affecting the
grinding and final coffee taste and effect, please do not put too many coffee beans into the bean box.
3. Put the funnel into the left powder receiving support as shown in Figure 5
09 z'