EN
Making double cups of coffee: in standby mode, install the double cup filter screen into the funnel,
load about 19gof coffee powder, use the powder hammer and press the coffee powder with a force of
about 12.5kg, then align the funnel assembly with the clamping position of the funnel support, screw in
the funnel support counterclockwise, put the coffee cup on the coaster, press the double cup of coffee
key to enter the double cup of coffee making function. When the set flow (about 60ml) is reached, the
system automatically stops working and the double cup of coffee function ends, All the lights on the
panel are always on, and the whole machine enters the standby state.
Special reservation:
1. The single cup and a cup of coffee, the user can according to the habits and the need to adjust the
specific flow of coffee, specific operation is as follows: push the single or double coffee cup long, or
indicator lights flashing at the same time, and start the coffee, when the amount of flow to achieve the
user wants to loosen the single or double file button, buzzer sounded, the system will record user traffic.
When the user uses it again, the single and double cup flow will run according to the user's last set flow;
(Only the flow rate in 20ml-125ml single cup (250ml double cup) is regarded as valid record)
2. Long press program setting key + single cup coffee key or program Setting key + double cup coffee key
to restore single or double cup coffee flow to factory setting;
When brewing the coffee, make sure the funnel is rotated in the correct position as shown below
II
NO 1
II
CCC.
NO 3
Steam function: in standby state, the knob is turned to " IJ " to enter the steam function. At this time,
the steam/hot water indicator blinks and the steam function runs. Turn the knob to the center position
" the steam function stops, the machine enters the standby state
Hot water function: in standby state, the knob is turned to " and the steam/hot water indicator
blinks, and the hot water function runs. Turn the knob to the middle position " ",the hot water function
stops, and the machine enters the standby state.
Attention:
1. Steam function will produce high temperature steam, please pay attention to avoid scalding
when using.
2. In order to ensure the foaming effect of milk, please rotate the knob to 12 0 'clock after the
steam function runs for 3-5 seconds, then extend the steam tube into the milk, and then rotate
the knob to the steam position for milk foaming.
3. After using this function, please turn the knob to 12 0 'clock in time. If it does not turn back,
the indicator will alarm and blink
08
To Next Page
Loading...