EN
(Figure 5)
4.Press the single cup grinding button, the grinder will start and stop automatically after reaching the
set grinding amount. You can also operate the single cup grinding button to stop halfway.
5.Press the double cup grinder button, the grinder starts, automatically stops after reaching the set
amount of grinding powder, you can also operate the double cup grinder button to stop halfway.
6.Take out the funnel, knock the funnel on the table, and pre-powder the coffee in the strainer.
7.Press the coffee powder with a force of about 12.5kg.
8.Screw the funnel counterclockwise into the funnel support, and select the corresponding single or
double button according to the filter cup used:
Program :
1. When the bean box is not installed, the single cup grinding bean key and the double cup
grinding bean key are always bright red at the same time.
2.When the grinding function cannot be used normally, the single cup grinding key and double
cup grinding key flash, accompanied by three beeps.
3.1n order to protect the bean grinding system, when the bean grinding function lasts for 3
minutes and the intermediate stop time is lessthan 6 minutes, the system will restrict the normal
use of the bean grinding function. After the interval reaches 6 minutes, the system will automati-
cally release this restriction and the bean grinding system will return to normal.
Adjustment of grinding time: the user can independently set the grinding time of pressing the single
cup (or double cup) grinding button for a single time. The specific operation method is to press and hold
the single cup (or double cup) grinding button. At this time, the corresponding indicator flashes, and the
grinder will run. When it runs to the time required by the user, release the single cup (or double cup)
grinding button, the buzzer rings, and the system will record this time, The next time you press the
single cup (or double cup) grinding button, the system will execute the newly set time (the system only
records the time exceeding 5 seconds, and does not record the time less than 5 seconds). At the same
time, press and hold the program setting key + single cup (or double cup) bean grinding key to restore
the factory setting of bean grinding time.
3. Clean Bean grinder cleaning
During the use of the grinder, the powder outlet channel will be blocked due to the influence of coffee
beans and external factors. Please clean the powder outlet channel in time in case of the following
circumstances
10
To Next Page
Loading...