HiBREW H7A - Page 13

EN
Place container
Place a 1 liter container under the brewing head and
another 1 liter container under the steam tube.
After completing the above steps, you can start the cleaning procedure as follows:
1. When the system detects that the flow of the whole machine reaches 15L, the descaling function will
start and automatically enter the descaling program ;
2. In standby mode, long press the single cup coffee key + double cup coffee key + program setting key to
start the descaling program
Whenthe dirt removalindicatorlight andthe Q) power indicatorlight areon andflash,pleaseperform
the following operations:
Step 1: Start the descaling cycle
Turn the knob tolJ\ position
QThesteam/ hotwaterindicatorisalwayson,andthedescalingindicatorand(Dpowerlightflash
When the water pump starts, the hot water will be released from the brewing head and steam pipe. After
2 minutes, the water pump will make different sounds.
When the hot water has stopped releasing from the brewing head and steam pipe, this step is completed
and turn the knob to the o position.
Step 2: prepare for cleaning
Important: allow a maximum of 5 minutes to complete the following steps before the descaling cycle exits.
The steam conduit and the brewing head need to be cleaned with fresh water to remove the descaling
solution
• Flushing water tank
• Fill the water tank with water
Step 3: start cleaning
Turn the knob to the position;
• Empty container
Thesteam/ hotwaterindicatorisalwayson,andthedescalingindicatorandpowerlightQ)flash;
When the water pump starts, the hot water will be released from the brewing head and steam pipe. After
2 minutes, the water pump will make different noises;
When the hot water has stopped releasing from the brewing head and steam pipe, the descaling is
completed and the knob is turned to the position
Descaling cycle completed
Turn the knob to the position and light up at the same time.
To indicate that the descalingcycle is complete, the appliance will beep and the indicator light(Dstops
flashing.
The appliance will return to standby mode.
\ 12