7 8
FITWARE SERIES
FitWare FM Pulse
english
english
SET DATA
1. Use the S1 key to advance to the DATA mode.
2. Upon entering the Data Screen, AGE will automat-
ically be displayed on the screen.
3. Review your Data settings using the S4 key
4. To program the Data screen, PRESS & HOLD the
S2 key for 2-seconds.
5. "ADJUST" will be shown on the display for 2-
seconds followed by "AGE” with the number of
years flashing.
6. Adjust Age, Gender, Weight, Stride (length) using the
S3 or S4 keys.
NOTE: See “Determining Your Stride Length” on
following page.
7. In the WEIGHT and STRIDE (length) programming
windows use the S1 key to change the units from
metric (Kg and Cm) to English (Lbs and In.)
NOTE: For the distance and calorie functions to
work properly, the Data section of the FitWare unit
must be programmed as accurately as possible.
Aerobic Pulse Rate Zone (FitWare Pulse Units Only)
8. On the FitWare Pulse unit you will also adjust HI and
LO PULSE LIMITS and turn the PULSE LIMIT
ALARM ON or OFF.
9. Store each setting to memory and advance to the
next variable using the S2 key.
INPUT YOUR PERSONAL DATA
(ALL MODELS)
DETERMINING YOUR STRIDE LENGTH
1. You will need a tape measure to accurately measure
your stride.
2. Mark a spot on the ground. Start with your toe to
that point and take 10 natural strides of the type you
want to measure (run, walk, jog, etc).
3. Mark the place where the toe of your forward foot
stopped.
4. Measure the distance between the two points, and
divide by 10
INPUT YOUR PERSONAL DATA
(ALL MODELS)
To Next Page
Loading...