HIKVISION ColorVu

Configuration Guide of ColorVu
Camera LED Supplement Light
1 Brightness configuration of LED supplement light
Note:
1, When the camera is electrified, it is self-check at full power, and the supplement light is bright,
so avoid to stare at supplement light of camera;
2, LED supplement light will be locked in the light-on state for an hour after continuous switching
for 5 times in a short time due to manual test or ambient brightness change.
Path：【 Configuration】-【System】-【System Settings】-【External Device】
1.1 Enable supplement light
1.2 LED light brightness adjustment
LED light brightness can be set to Manual mode or Auto mode.
1.2.1 Manual mode
1. Select Manual mode in LED Light Brightness Adjustment;

HIKVISION ColorVu Specifications

General

Color Night Vision	Yes
Aperture	F1.0
Image Sensor	CMOS
Compression	H.265+/H.265/H.264+/H.264
Audio	Built-in microphone
Weatherproof Rating	IP67
Sensor Type	Progressive Scan CMOS
Focal Length	2.8mm (other options available)
Operating Conditions	-30 °C to 60 °C (-22 °F to 140 °F), Humidity: 95% or less (non-condensing)
Power Supply	DC12V ± 25%, PoE (802.3af)
Resolution	2 MP to 8 MP (depending on the specific model)
Lens	Fixed (various focal lengths available depending on the model)

Summary

Brightness Configuration of LED Supplement Light

Enable Supplement Light

Enables or disables the camera's LED supplement light feature.

LED Light Brightness Adjustment

Configures brightness levels for the LED supplement light.

LED Light On Mode Configuration

Manual Mode for Brightness Adjustment

Sets LED brightness manually, with a range from 1 to 100.

Auto Mode for Brightness Adjustment

Automatically adjusts brightness based on ambient light conditions.

Timing Mode for LED Light On

Schedules the LED supplement light to turn on/off based on start and end times.

Auto Mode for LED Light On

Automatically controls the LED light based on ambient brightness and sensitivity settings.