The value of X indicates that the shutter speed is 1/X second. If you set the SHUTTER
value bigger (shutter speed is faster), the amount of entering light per second is fewer,
and the image is darker.
(2) Slow shutter. Set SLOW SHUTTER as ON, the shutter speed can automatically slow down to
extend exposure time under low lighting circumstances to obtain clearer image.
Task 7: Configure exposure compensation.
You can set the EXPOSURE COMP value from 0 to 14. The default value is 7. You can adjust this
value to increase the brightness of the image.
Task 8: Configure white balance.
You can set WHITE BALAN as HAUTO, AUTO, INDOOR, OUTDOOR, SELFDEF (self-defined), ATW
(auto-tracking) and HAUTO (half-auto).
AUTO:
In Auto mode, the dome retains color balance automatically according to the current color
temperature.
INDOOR, OUTDOOR:
These two modes are for indoor use and outdoor use respectively.
SELFDEF:
In this mode, you can adjust the color temperature manually to meet your own demand.
In SELFDEF mode, you need to adjust the RED and BLUE values manually.
ATW:
In auto-tracking mode, white balance is continuously being adjusted in real-time according to
the color temperature of the scene illumination.
HAUTO:
Selecting this mode, the viewed image retains color balance automatically according to the
current color temperature.
Task 9: Configure the image flip.
If you turn the IMAGE FLIP function on, the image will be flipped diagonally along its central
axis, shown as the mirror reflection of the image.
Task 10 Configure focus limit
AUTO, 1 CM, 1 M, 3 M, 5 M and 20 M are selectable in FOCUS LIMIT. When set it as the AUTO, the
focus limit automatically adjusted according to the zoom limit.
Task 11: Configure the noise reduction.
To reduce the image noise, you can set the value of 2D DNR and 3D DNR respectively. The
greater the value is, the less the noise will be in the low illumination environment. You can also
disable the function by turning the value as OFF.
To Next Page
Loading...
Need help?
General
