Need help?Do you have a question about the HIKVISION DS-2AE7230TI-A and is the answer not in the manual?
General| Type | CCTV security camera |
|---|---|
| PTZ control | Yes |
| Languages support | CHI (SIMPL), ENG |
| Number of languages | 2 |
| Placement supported | Outdoor |
| Connectivity technology | Wired |
| Maximum operating distance | 120 m |
| Pan range | 0 - 360 ° |
| Pan speed | 240 °/sec |
| White balance | ATW, Auto, Indoor, Manual, Outdoor |
| Tilt angle range | -15 - 90 ° |
| Camera shutter speed | PAL: 1-1/10000s, NTSC: 1-1/10000s s |
| Minimum illumination | 0 lx |
| Sensor type | CMOS |
| Optical sensor size | 1/3 \ |
| Effective sensor resolution | 1920 pixels |
| Interface | BNC |
| AC input voltage | 24 V |
| Power consumption (max) | 30 W |
| Power over Ethernet (PoE) | No |
| Form factor | Dome |
| Mounting type | Desk/Wall |
| Product color | White |
| International Protection (IP) code | IP66 |
| Maximum resolution | 1920 x 1080 pixels |
| Supported video modes | 1080p |
| Analog signal format system | NTSC, PAL |
| Signal-to-Noise Ratio (SNR) | 50 dB |
| Digital zoom | 16 x |
| Optical zoom | 30 x |
| Focal length range | 4 - 120 mm |
| Maximum aperture number | 4.4 |
| Number of cameras | 1 |
| Operating temperature (T-T) | -30 - 65 °C |
Weight and Dimensions| Height | 353.4 mm |
|---|---|
| Weight | 4500 g |
| Diameter | 220 mm |
Details FCC compliance requirements and conditions for the device's operation.
Explains CE marking and compliance with EU directives like WEEE and battery.
Critical safety guidelines to prevent serious injury or death.
Important precautions to prevent equipment damage or minor injury.
Describes the E series speed dome's capabilities and intended uses.
Lists and explains essential functions like Coaxial Control, HD Output, and Scan Modes.
Details self-test routines and system information display on startup.
Guides on manual control of pan, tilt, zoom, and focus.
Explains pre-programmed positions and their special functions.
Details various data displayed on the monitor, such as zoom and PT status.
Guides on how to enter and navigate the main menu system.
Covers checking and configuring system details like address, baud rate, and time.
Details settings for focus, zoom, exposure, white balance, and image quality.
Manages PTZ movements, presets, patrols, patterns, timing tasks, and zones.
Configures alarm linkage actions, parameters, and output signals.
Resets all dome settings to factory defaults.
Resets camera settings (image, lens, display) to defaults.
Remotely reboots the speed dome.
Describes the characteristics and load ability of RS485 bus.
Details the maximum transmission distance based on baudrate.
Explains daisy-chain connection and simplified methods for RS485.
Provides solutions for common RS485 communication problems.
To Next Page