Need help?Do you have a question about the HIKVISION DS-2CD2612F-I(S) and is the answer not in the manual?
General| Image Sensor | 1/3" Progressive Scan CMOS |
|---|---|
| Signal System | PAL/NTSC |
| Minimum Illumination | 0.01 Lux @(F1.2, AGC ON), 0 Lux with IR |
| Lens Mount | M12 |
| Wide Dynamic Range | Digital WDR |
| Digital noise reduction | 3D DNR |
| Audio Compression | G.711 / G.726 |
| Security | User authentication, Watermark |
| Ingress Protection | IP66 |
| IR Range | Up to 30 m |
| Max Resolution | 1920x1080 |
| Effective Pixels | 2.07 MP |
| Shutter time | 1/100000 s |
| Lens | 2.8 mm / 4 mm / 6 mm |
| Day & Night | IR Cut Filter |
| Video Compression | H.264 |
| Frame Rate | 30 fps @ 1920 × 1080 |
| Image Settings | Saturation, Brightness, Contrast adjustable by client software or web browser |
| Network Storage | NAS |
| Alarm Trigger | Motion detection, Network disconnection, IP address conflict |
| Protocols | TCP/IP, HTTP, DHCP, DNS, DDNS, RTP, RTSP, SMTP, NTP, SNMP, IGMP |
| Network Interface | RJ45 (10/100Base-T) |
| Operating Conditions | -30 °C to 60 °C; Humidity 95% or less |
| Power Supply | DC 12V ± 25%, PoE (802.3af) |
Details FCC compliance rules and operating conditions for the network camera.
Explains CE marking, WEEE, and RoHS directives applicable to the product.
Outlines critical warnings to prevent serious injury or death.
Details cautions to prevent potential injury or material damage.
Describes the physical appearance and identifies key components of the camera.
Illustrates the basic wiring connections for the network camera.
Step-by-step guide for installing an SD card into the camera.
Instructions for directly mounting the camera to a wall.
Guide for mounting the camera using a junction box.
Instructions for installing the camera with a gang box.
Explains 3-axis adjustment (pan, tilt, rotation) for optimal camera placement.
Details how to adjust the camera's zoom and focus using levers.
Shows the cable connection setup between the network camera and PC via a switch.
Guides on obtaining and setting the camera's IP address using SADP software.
Lists the necessary operating system, CPU, RAM, display, and browser versions.
Steps to access the camera interface via a web browser and login.
To Next Page