Make sure that the wall is strong enough to withstand at
least 4 times the weight of the device and the mount.
Make sure that the power has been disconnected before
you wire, install, or disassemble the device.
Make sure that no reective surface is too close to the
device lens. The IR light from the device may reect back
into the lens causing reection.
CAUTION: Hot parts! Burned ngers when
handling the parts. Wait one-half hour after
switching off before handling parts. This
sticker is to indicate that the marked item can be hot and
should not be touched without taking care. For device with
this sticker, this device is intended for installation in a
restricted access location, access can only be gained by
service persons or by users who have been instructed
about the reasons for the restrictions applied to the location
and about any precautions that shall be taken.
Symbols and Marks
Notice
Warning
Forbidden
Correct
Incorrect
Turn to page A and continue.
i. Not necessarily included accessory.
ii. Variable accessory amount.
iii. Skip this step if not required.
To Next Page
Loading...
Need help?
General
