Thermal & Optical Bi-spectrum PTZ Network Camera User Manual
57
9.14 Set PTZ Priority
The function can set the PTZ priority of different signals.
Steps
1. Go to Configuration → PTZ → Prioritize PTZ.
2. Set the priority signal and delayed time.
Network
The network signal controls the device with priority.
RS-485
The RS-485 signal controls the device with priority.
Delay
It refers to the time interval of PTZ operation controlled by different signals. When the
operation with high priority is finished, the low priority signal controls the device after the
setting interval.
3. Click Save.
To Next Page
Loading...
