Thermal & Optical Bi-spectrum PTZ Network Camera User Manual
50
2. Choose one of the following methods to enable the function.
– Click .
– Call patrol path No.8.
Select and call preset No.45.
9.4 Set Pattern Scan
The device can move as the recorded pattern.
Steps
Note
This function is only supported by certain models.
1. Click to show the PTZ control panel, and click .
2. Select one pattern scan path that needs to be set.
3. Click to start recording pattern scan.
4. Click PTZ control buttons as demands.
Note
Recording stops when the space for pattern scan is 0%.
5. Click to complete one pattern scan path settings.
6. Click to call pattern scan.
Note
If you need to delete all the pattern scans, go to Configuration → PTZ → Clear Config, and check
Clear All Patterns, and click Save.
9.5 Set Linear Scan
The device can perform auto scan in setting area for fire source detection.
Steps
1. Go to Configuration → PTZ → Linear Scan.
2. Select the camera channel.
To Next Page
Loading...
