HIKVISION DS-2TP31B-3AUF - Set Palette; Set Temperature Alarm

 Emissivity: Set the emissivity of your
target as the effectiveness in emitting
energy as thermal radiation.
Note: Refer to the 6.1 Common
Material Emissivity Reference for
emissivity values.
 Distance (m/feet): Set the straight-line
distance between the target and the
device.
Note: The recommended
thermometry distance is 0.2 m to 2
m with target size 80 × 80 mm.
 Rule: Select Center Spot and Cold Spot
to show the center temperature and
min. temperature in the live view
interface.
4 Press / button to select
desired parameter, and press
button to enable it.
5 If necessary, press / button
to increases / decrease the setting
values. Hold / button to
change the value quickly.
6 Press button to save and exit.
4.2 Set Palette
Different palette modes display different
temperature colors. You can analyze image by
different palette colors.
Steps:
1 In the live view interface, press
button show the menu bar.
2 Press / button to select
Palette.
3 Press button to select palette
mode and the live view interface
displays the according palette color.
4 Press button to save and exit.
4.3 Set Temperature Alarm
After enabling this function, when the device
detects temperature that is higher than the
set alarm threshold, Max. Temperature on the
live view interface will flash.
Steps:
1 In the live view interface, press
button show the menu bar.
2 Press / button to select
Temperature Alarm.
3 Press , and press /
button to increase or decrease alarm
temperature threshold.
4 Press button to exit.