DS-73xxHUI-K4, DS-73xxHQI-K4, DS-90xxHUI-K8 DVR User Manual
UM DS-73xxHUI-K4 DS-73xxHQI-K4 DS-90xxHUI-K8 092017NA 164
Before You Start
The RAID function should be enabled.
As the default array type is RAID 5, install at least three HDDs in you device. If
more than 10 HDDs are installed, two arrays can be configured.
1. Enter the RAID configuration interface, Menu > System Configuration >
RAID.
Figure 220, Physical Disk Interface
2. Check the corresponding HDD No. checkbox to select i
t.
3. Click One-touch Config to enter the One-touch Array Configuration
interface.
Figure 221, One-touch Array Configuration
4. Edit the array name in the Array Name text filed and click OK to start
configuring the array.
If you install four HDDs or more for one-touch confi
guration, a hot spare
disk will be set by default. It is recommended to set a hot spare disk to
automatically rebuild the array if the array becomes abnormal.
5. When the array configuration is completed, click OK in the pop-up
message box to finish the settings.
To Next Page
Loading...
