DS-73xxHUI-K4, DS-73xxHQI-K4, DS-90xxHUI-K8 DVR User Manual
UM DS-73xxHUI-K4 DS-73xxHQI-K4 DS-90xxHUI-K8 092017NA 52
When the UTC protocol is selected, all the other parameters such as baud rate, data
bit, stop bit, parity, and flow control are not configurable.
5. (Optional) Click Copy to copy the settings to the other channels. Select the channels
you want to copy to and click OK to return to the PTZ Parameters Settings interface.
Figure 59, Copy to Other Channels
6. Click OK to save the settings.
7. (Optional) Check the Enable Omnicast Control checkbox to enable the PTZ control of
the selected camera via Omnicast VMS of Genetec.
4.2 Setting PTZ Presets, Patrols, and Patterns
Before You Start
Ensure that the presets, patrols, and patterns are supported by PTZ protocols.
4.2.1 Customizing Presets
Purpose
Follow the steps below to set the preset location you want the PTZ camera to
point to when an event occurs.
1. Go to Menu > Camera > PTZ.
To Next Page
Loading...
