Access Control Terminal·User Manual
124
2. Select the device type, serial port type, serial port, baud rate, and other
parameters of the Card Dispatcher.
3. Click the save button to save the settings.
It is supported using card type as regular and Wiegand.
When the BEEP is selected as “YES”, the audio will be off when you click
the “SAVE” if the Card Reader Configuration is set wrong; the audio will be
on when you click the “Save” and when you insert the card reader if the
configuration is set correct.
You can click the Restore Default Value button to restore the defaults of
all the local configuration.
Fingerprint Machine Configuration
Steps:
1. Click the icon on the System Configuration
interface to open the Fingerprint Machine Configuration page.
To Next Page
Loading...
