Access Control Terminal·User Manual
125
2. Select the device type, serial port number, baud rate, device code, and
overtime parameters of the fingerprint machine.
3. Click the Save button to save the settings.
Models DS-K1T802M and DS-K1T802E do not support the fingerprint
machine funciton.
It is supported using device type as Optical Fingerprint Collecting
Instrument and Capacitive Fingerprint Collecting Instrument.
The serial port number should correspond to the serial port number of PC.
The baud rate should be called according to the external fingerprint card
dispatcher. The default value is 19200.
Overtime refers to the valid fingerprint collecting time. If the user does
not input a fingerprint or inputs a fingerprint unsuccessfully, the device
will indicate that the fingerprint collecting is over.
You can click the Restore Default Value button to restore the defaults of
all local settings.
Manual Capture Configuration
Steps:
To Next Page
Loading...
