HIKVISION DS-k2210 Quick Start Guide

Title:
Elevator control wiring and simple
configuration （Button mode）
Version:
v1.0
Date:
5/12/2017
Product:
Access Control Device
Page:
1 of 7
Elevator control wiring and simple configuration
（Button mode）
Preparation：
Prepare the following equipment for the test, complete the test and then install
DS-k2210 DS-k2m0016 DS-k1106
Step 1: DIP Switch
The DIP switch of the card reader should be decimal 1 or 2.
The DIP switch of Ds-2100 should be decimal 1or 2.
The DIP switch of distributed elevator controller (DS-K2M0016A) is decimal 3-10
The device uses binary dialing codes
If you want to get dialing 3, Dial 1 and 2,if you want to get 4, Dial 3
Step2:Wring

HIKVISION DS-k2210 Specifications

General

DC input voltage	12 V
Power source type	DC
Housing color	Gray
Relay outputs	5

Weight and Dimensions

Depth	167 mm
Width	105 mm
Height	30 mm