Access Control Terminal·User Manual
53
2. Click to pop up the Zone Settings window.
3. Set the zone name, the detector type, the zone type and the sensitivity.
4. Click Save to save the settings.
Or click Copy to… to copy the parameters to other zones.
Configuring Relay Parameters
Steps:
1. Click Alarm -> Relay.
You can view the relay parameters.
2. Click the to pop up the Relay Parameters Settings window.
3. Set the relay name and the output delay.
4. Click Save to save the paramters.
Or click Copy to… to copy the relay information to other relays.
Configuring Access Control Parameters
Steps:
To Next Page
Loading...
