HIKVISION DS-KB6403-WIP User Manual

14
Connect Wi-Fi
You should set the Wi-Fi connection before adding the doorbell to the App and
operating the doorbell.
Steps
1. In the Home page of the App, tap More -> Settings -> Wi-Fi Settings to enter the
Wi-Fi settings page.
2. Input the wireless network name and password that your mobile phone has
connected to.
3. Tap Generate to generate a QR code.
4. Use the camera of the doorbell to scan the QR code, so as to finish the Wi-Fi
connection.
Figure 3-2 Scan the Wi-Fi QR Code
The suggested scanning distance is 5 to 10 cm. The doorbell gives a beep for success.
Add and Activate Doorbell
Steps
1. In the App Home page, tap “+” on the upper-right corner to add the doorbell.
Figure 3-3 Scan the Doorbell QR Code

HIKVISION DS-KB6403-WIP Specifications

General

Color	Yes
Video codecs	H.264
Certification	CE
Frequency band	2.4 GHz
Number of buttons	2 buttons
Connectivity technology	Wireless
Sustainability certificates	RoHS
Number of displays supported	-
Maximum number of cameras supported	1
Voice codecs	G.711u
Megapixel	2 MP
Sensor type	CMOS
Supported video modes	720p
Viewing angle, vertical	96 °
Viewing angle, horizontal	180 °
Compatible memory cards	MicroSD (TransFlash)
Maximum memory card size	128 GB
LED type	IR
Night vision distance	5 m
Operating temperature (T-T)	-30 - 50 °C
Operating relative humidity (H-H)	10 - 90 %
Display diagonal	- \
Operating system installed	Linux
Product color	Gray
International Protection (IP) code	IP54
Supported network protocols	TCP/IP, RTSP
Power consumption	0.6 mA
Operating voltage (door opener)	12 V

Weight and Dimensions

Depth	122.4 mm
Width	45.9 mm
Height	28.1 mm