HIKVISION DS-KH6320-LE1B

Wizard
Tap Wizard and set the language, network, indoor staon type, device No., and select a device
according to the wizard. Refers to
Quick Operaon (For Normal Device) for the details.
Preference
Tap Sengs → to enter the preference page.
Shortcut
Sengs
Enable call elevator, alarm, call management center, or leave message and the icon will be
displayed on the home page.
Zone Sengs
Note
Only when enable Alarm in the shortcut sengs, can the Zone Sengs displayed on the
Preference page.
Set the zone parameters. For details, see Zone Sengs .
Scene Sengs
Note
Only when enable Alarm in the shortcut sengs, can the Scene Sengs displayed on the
Preference page.
Set the scene parameters, including the stay mode, the away mode, the sleeping mode, or
customize the scene. For details, see Arming Mode Sengs .
3.9 Output
Sengs
You can set and control the connected output devices via the output sengs page. You can change
the relay' name, and open
duraon. You can also set to display the relay buon on the main page
or not.
Steps
1.
Tap Sengs → → Output Sengs .
Note
●
Supports up to 2 relays.
●
If no relays displayed on the page, the device may not support the funcon.
2.
Select a relay and set the parameters.
Name
You can change the relay's name.
Network Indoor Staon Conguraon Guide
39