HIKVISION DS-MCW407 Series - Safety Instructions; Laws, Power Supply, and Environment

Safety Instrucon
Laws and Regulaons
Use of the product must be in strict compliance with the local
laws and regulaons. Please shut down the device in prohibited
area.
Power Supply
•
Use of the product must be in strict compliance with the local
electrical safety regulaons.
•
Use the power adapter provided by
qualied manufacturer.
Refer to the product
specicaon for detailed power
requirements.
•
It is recommended to provide independent power adapter for
each device as adapter overload may cause over-heang or a
re hazard.
•
Make sure that the power has been disconnected before you
wire, install, or disassemble the device.
•
DO NOT directly touch exposed contacts and components once
the device is powered up to avoid electric shock.
•
DO NOT use damaged power supply devices (e.g., cable, power
adapter, etc.) to avoid electric shock,
re hazard, and
explosion.
•
DO NOT directly cut the power supply to shut down the device.
Please shut down the device normally and then unplug the
power cord to avoid data loss.
•
DO NOT block the power supply equipment to plug and unplug
conveniently.
•
Make sure the power supply has been disconnected if the
power adapter is idle.
•
Make sure the device is connected to the ground
rmly.
Transportaon,
Use, and Storage
•
To avoid heat
accumulaon, good venlaon is required for a
proper operang environment.
•
Store the device in dry,
well-venlated, corrosive-gas-free, no
direct sunlight, and no heang source environment.
•
Avoid
re, water, and explosive environment when using the
device.
•
Avoid lightning strike for device
installaon. Install a lightning
arrester if necessary.
•
Keep the device away from
magnec interference.
•
Avoid device installaon on vibratory surface or places, and
avoid equipment
installaon on vibratory surface or places
subject to shock (ignorance may cause device damage).
•
DO NOT touch the heat
dissipaon component to avoid burns.
vi