2. After the speaker has been configured with correct network parameters, you can login to the
web page of the speaker. Configure the following parameters on the speaker web page:
1) Go to the speaker web page - Server, enter the HikCentral server IP (here is
192.168.1.110) as server IP, and enter 8877 as the server port.
For the user name and password for server, it is recommended to enter the username
and password of the speaker. And this should match the username and password used in
adding the device on HikCentral. Alternatively, you can enter any username or password
here as long as it matches those used in HikCentral while adding the speaker.
Note: 8877 is the default HikCentral port used for communication with speaker and can
be changed in HikCentral service manager if needed. Device proactively registers to
HikCentral via this port, so in the Windows firewall rule setting, the incoming connections
to this port shall be allowed. For the configured parameters to take effect on Speaker,
you would need to logout the speaker.
To Next Page
Loading...