HIKVISION DS-PK-L Series - Page 5

3
Name Funcon Key Notes
Tesng Walking tesng [Code] [*] [6] [0][#]
Exing walking tesng [Code] [*] [6] [2][#]
Signal strength tesng [Code] [*] [6] [3][#]
Exing signal strength
tesng
[Code] [*] [6] [4][#]
Panic alarm Panic
[ ]
Press at least 3 s
Fire alarm Fire alarm
[ ]
Press at least 3 s
Equipment status
query
System fault status [status] Used for system fault query
Wireless device
enrollment/ removal
Wireless device
enrollment/ removal
[Code] [ ] [Operaon]
[Device Type][RS- 485
Address][#]
Note: No corresponding digits can be omied in all elds.
Operaon mode: 1 represents enrollment, and 2 represents removal (not supported).
1 bit.
Device type: 01 represents the remote controller (not supported);
02 represents the detector or single zone module;
03 represents the repeater;
04 represents the output module; and
05 represents the siren.
2 bits.
RS-485 address: 00 to 31.
2 bits.
RS-485 wired device Delete the selected RS- 485
wired device
[code] + [*] +
[Engineering] + [485
address] + [#]
Delete the selected RS- 485 wired device corresponding to RS- 485 address.
NOTE: The paron number is two digits. For example, you must input 01 in paron 1 that 0 cannot be omied.
The RS-485 address is two digits. For example, you must input 03 if the address is 3 that 0 cannot be omied.
Code: It means that codes of all user categories can be entered, and whether there are corresponding privileges according to the actual conguraon items.