31
2. Tap → System → System Options → Arm Options to enter the page.
You can set the following parameters:
Arm with Fault
Check the faults in the Enable Arming with Fault list, and the device will not stop the arming
procedure when faults occurred.
Early Alarm
If you enable the function, when the zone is armed and the zone is triggered, the alarm will be
triggered after the set delay time.
Note
The early alarm will be taken effect only after the delayed zone is triggered.
3. Tap Save.
Enrollment Mode
Steps
1. On the device list page, tap the AX PRO and then log in to the device (if required) to enter the
page.
2. Tap → System → System Options → Enrollment Mode to enter the page.
3. Tap Enter the Enrollment Mode. You can enroll the peripheral by triggering it.
Network Camera
Add Cameras to the AX PRO
Steps
1. In the site, tap the AX PRO and then log in to the device (if required).
2. Tap → Network Camera → Network Camera Channel to enter the page.
3. Tap Add Channel.
4. Enter IP address, port, the user name and password of the camera.
5. Tap Save Icon.
6. Optional: tap Edit or Delete to edit or delete the selected camera.
Set Video Parameters
Steps
1. In the site, tap the AX PRO and then log in to the device (if required).
2. Tap → Network Camera → Event Video Settings to enter the page.
3. Select a camera and set the video parameters.
To Next Page
Loading...
Need help?
General
