33
Note
You should enable the Panel Management Notification function on the Web Client of
Communication Parameters → Event Communication before enabling the Late to Disarm
function.
Late to Disarm Time
Set the time point mentioned in Late to Disarm.
Auto Arm Sound Prompt
After disabled, the buzzer will not beep before auto arming.
Weekend Exception
If enabled, Auto Arm, Auto Disarm, and Late to Disarm are disabled on the weekend.
Holiday Excepted
Enable the function and the zone will not be armed/disarmed in the holiday. You should set the
holiday schedule after enabling.
Note
Up to 6 holiday groups can be set.
Communication
Wired Network
Steps
1. In the site, tap the AX PRO and then log in to the device (if required).
2. Tap → Communication Parameters→ Wired Network to enter the page.
3. Set the parameters.
– Automatic Settings: Enable DHCP and set the HTTP port.
– Manual Settings: Disabled DHCP and set IP Address, Subnet Mask, Gateway Address, DNS
Server Address.
4. Optional: Set correct DNS server address if the device needs to visit Hik-Connect server via a
domain name.
5. Click Save.
Cellular Data Network
Steps
1. In the site, tap the AX PRO and then log in to the device (if required).
2. Tap → Communication Parameters→ Cellular Data Network Settings to enter the page.
To Next Page
Loading...
Need help?
General
