58
The device will push notifications when the control panel system status is changed.
Zone Status
The device will push notifications when the zone status is changed.
Peripherals Status
The device will push notifications when any peripheral status is changed.
Panel Operation
The device will push notifications when the user operates the AX PRO.
Smart Alarm Event
The device will push notifications when the alarm is triggered in thermal cameras.
5. Tap Phone Call and SMS.
6. Tap + Add Phone Number to enter the phone number.
7. Tap the added phone number to enable Phone Call and SMS according to your need.
8. (For Phone Call) Set Numbers of Calling.
9. (For SMS) Set Arming Permission, Disarming Permission and Alarm Clearing Permission for
areas.
General Hint
You can enter Common Message. When the alarm is triggered, your customized content will be
added at the beginning of the message sent by the system.
You can import Common Voice. When the alarm is triggered, your customized voice will be
added at the beginning of the content of the phone dialed by the system.
Note
Only WAV format is supported, up to 512 KB or up to 15 s.
10. Check notifications.
Alarm Receiving Center (ARC)
You can set the alarm receiving center's parameters and all alarms will be sent to the configured
alarm center.
Steps
1. In the site, tap the AX PRO and then log in to the device (if required).
2. Tap → Communication Parameters→ Alarm Receiving Center (ARC) to enter the page.
3. Select an ARC and enable it.
Protocol Type
Select the Protocol Type as ADM-CID, ISUP, SIA-DCS, *SIA-DCS, *ADM-CID or CSV-IP to set
uploading mode.
To Next Page
Loading...
Need help?
General
