HIKVISION DS-PM1-D User Manual

60
Wired &Wi-Fi
The system will select wired network first. If no wired network detected, it will select Wi-Fi
network.
Cellular Data Network
The system will select cellular data network only.
4. Enable Periodic Test. Enter the periodic test interval.
5. Tap Save.
Notification by Email
Steps
1. In the site, tap the AX PRO and then log in to the device (if required).
2. Tap → Communication Parameters→ Notification by Emails to enter the page.
3. Enable Email.
4. Enter the sender name, sender email address, SMTP server address, SMTP port, user name and
password.
5. Select the encryption type as None, SSL or TLS.
6. Enable Server Authentication.
7. Enter receiver name and receiver email address. Tap Test Receiver Email Address to test
whether the email address is correct.
8. Tap Save.
Check Balance
Steps
1. In the site, tap the AX PRO and then log in to the device (if required).
2. Tap → Communication Parameters→ Check Balance to enter the page.
3. Enter the USSD number.
4. Tap Check Balance.
FTP Settings
Steps
1. In the site, tap the AX PRO and then log in to the device (if required).
2. Tap → Communication Parameters→ FTP Settings to enter the page.
3. Select Preferred FTP or Alternated FTP, and enable FTP.
4. Configure the FTP parameters
FTP Type
Set the FTP type as preferred or alternated.
Protocol Type

HIKVISION DS-PM1-D Specifications

General

Brand	HIKVISION
Model	DS-PM1-D
Category	Control Unit
Language	English