87
Set the name of the repeater.
Set the polling rate of the repeater.
Set whether to cancel the enrollment of the repeater or not. If the link is enabled, the device
will be deleted.
6. Click to enter the Manual Retransmission Rules page.
Select the Device Type.
Check Active Functions.
Click OK, then the devices can be manually retransmitted.
Transmitter
You can set the parameters of the transmitter.
Steps
1. Click Device → Transmitter to enter the page.
2. Click Enroll, enter the Serial No. and select the device model to add a transmitter.
3. Click to edit the transmitter information.
To Next Page
Loading...
Need help?
General
