Auxiliary Care Radar • User Manual
4
Chapter 2 Software Instruction
Device Connection
You can connect the device via Wi-Fi or RS-485. Enter the corresponding information according to
different connection modes.
You can connect the radar via Wi-Fi.
Before You Start
Power on the radar (12 V).
Connect your computer to the radar AP hotspot.
SSID format: IRS60_xxxx.
Default password: abcd1234.
Use “ping” command to test if the computer is connected to the radar Wi-Fi.
1) Press the WIN button and R button at the same time.
2) Enter “cmd” and click OK.
3) Enter “ping 192.168.4.1” in the command line.
Open the IRS60-5 Radar PC tool and click On/OFF.
Set the network port parameters.
To Next Page
Loading...
