Auxiliary Care Radar • User Manual
5
IP address: 192.168.4.1.
Port: 20000.
Connection Setting
Click Confirm.
You can connect the radar via the serial port.
Open the software.
Enable On/OFF.
Select Serial Port.
Select Port.
Set BaudRate as 115200, Stop bit as 1, and Data bit as 8. No parity.
Set Radar Address.
Radar Address refers to the RS-485 communication sub-device address. 0 refers to the broadcast
address that covers all the sub-device.
Click Confirm.
Parameter Settings
Click to open the main page. You can read the radar firmware version, edit the RS-485 sub-
device address, set the radar mode, algorithm parameters, and upload mode.
To Next Page
Loading...
