Radar User Manual
1
Chapter 1 Introduction
1.1 Product Introduction
This document is a guide for radar installation and debugging. When the radar is
used as the trigger device or anti-fall device in the E&E system, you can refer
to the following debugging steps. The advantages of radar are convenient
installation, low construction cost and stable triggering of passing objects,
while the disadvantages are easy to cause false triggering
1.2 Radar logic
Trigger Radar
The trigger radar is connected to the camera and is usually installed 4 meters
away from the camera. When the vehicle passes the radar trigger signal, the
radar sends the signal to the camera, and the camera completes the capture
Anti-fall Radar
The anti-fall radar is connected with the barrier gate, and the radar
installation hole is reserved on the side of the barrier. When the vehicle
passes through the barrier gate and triggers the signal, the radar sends the
signal to the lane gate to keep the barrier gate open. When the vehicle passes
the radar, the signal disappears and the gate falls
To Next Page
Loading...
