Skip this step if the
bottom panel is
not assembled.
• Install HDD according to the following steps before using the device if the device is not
equipped with HDD at the factory.
• Skip this section if HDD is installed at the factory. You can follow the steps when changing
HDD.
Pry the gap marked as OPEN in
the bottom panel with slotted
screwdriver (self-provided).
Face the connecting
finger to HDD slot in
the bottom.
Requirements for HDD:
1. Capacity is less than or equal to 2 TB.
2. 2.5" SATA HDD (thickness is less than
or equal to 9.5 mm); 2.5" SATA SSD
(thickness is less than or equal to 7 mm).
Slowly push HDD (self-provided)
into the slot according to the
direction in the picture.
To Next Page
Loading...