● Input voltage should conform to IEC60950-1 standard: SELV
(Safety Extra Low Voltage) and the Limited Power Source with.
Please refer to the appropriate documentation for detailed
information.
● Do not connect several devices to one power adapter as
adapter overload may cause over-heating or a fire hazard.
● Please make sure that the plug is firmly connected to the power
socket. When the product is mounted on wall or ceiling, the
device shall be firmly fixed.
● If smoke, odor or noise rise from the device, turn off the power
at once and unplug the power cable, and then please contact
the service center.
Cautions
● CAUTION: Hot parts! Burned fingers when handling the
parts. Wait one-half hour after
switching off before handling
parts. This sticker is to indicate
that the marked item can be hot and should not be
touched without taking care. For device with this sticker,
this device is intended for installation in a restricted
access location, access can only be gained by service
persons or by users who have been instructed about the
reasons for the restrictions applied to the location and
about any precautions that shall be taken.
To Next Page
Loading...
Need help?
General
