HIKVISION iDS-TCE907-BR

Steps
Note
The funcon varies with dierent models. The actual device prevails.
1.
Go to Conguraon → Capture → Capture Images → Image Parameters .
Figure 1-20 Set Captured Image Parameters
2.
Set the captured image parameters.
Brightness
It refers to the max. brightness of the image.
Contrast
It refers to the contrast of the image. Set it to adjust the levels and permeability of the image.
Shuer
If the shuer speed is quick, the details of the moving objects can be displayed beer. If the
shuer speed is slow, the outline of the moving objects will be fuzzy and trailing will appear.
Gain
It refers to the upper limit value of liming image signal amplicaon. It is recommended to
set a high gain if the illuminaon is not enough, and set a low gain if the illuminaon is
enough.
Dayme Brightness Enhancement
It refers to the brightness of the image in the dayme. Higher value stands for brighter image.
Window Enhancement
In front light or back light scene, the ash light may not pass through the vehicle window, or
the image eect of the window is bad caused by the light. In this condion, you can check
Network Trac Camera Conguraon Manual
43