Need help?Do you have a question about the HIKVISION iDS-TCM203-A and is the answer not in the manual?
General| Form factor | Bullet |
|---|---|
| Mounting type | Ceiling/wall |
| Product color | Gray |
| Protection features | Water resistant |
| International Protection (IP) code | IP66 |
| Type | IP security camera |
| Certification | CE, FCC |
| Placement supported | Outdoor |
| Connectivity technology | Wired |
| Maximum operating distance | 50 m |
| Number of lenses | 1 |
| Focal length range | 8 - 32 mm |
| Maximum aperture number | 1.4 |
| Video streaming | Yes |
| Total megapixels | 2 MP |
| Maximum resolution | 1920 x 1080 pixels |
| Video compression formats | H.264, H.265, M-JPEG |
| Wi-Fi | No |
| Ethernet interface type | Gigabit Ethernet |
| Supported network protocols | TCP/IP, HTTP, HTTPS, FTP, DNS, DDNS, RTP, RTSP, RTCP, NTP, UPnP, IPv6, UDP |
| Compatible memory cards | MicroSD (TransFlash) |
| Maximum memory card size | 128 GB |
| RS-485 ports | 2 |
| Sensor type | CMOS |
| Optical sensor size | 1/1.8 \ |
| LED type | IR |
| Infra-red wavelength | 850 nm |
| Number of illumination LEDs | 3 |
| Minimum illumination | - lx |
| Field of view (FOV) angle | 42.5 ° |
| Audio input channels | 2 channels |
| Sustainability certificates | RoHS |
| Operating temperature (T-T) | -30 - 70 °C |
| Operating relative humidity (H-H) | 5 - 95 % |
| DC output voltage | 24 |
| Power source type | DC |
| Power consumption (max) | 15 W |
Weight and Dimensions| Depth | 428.5 mm |
|---|---|
| Width | 120 mm |
| Height | 132.8 mm |
| Weight | 3120 g |
Essential instructions for safe operation and installation.
Configuring live view, recording, and picture settings on the PC.
Setting installation parameters for speed detection.
Configuring network parameters like IP address and subnet mask.
Setting HTTP, RTSP, and SDK port numbers.
Steps to configure HTTPS for secure web access.
Settings for main and sub-stream video encoding.
Settings for capture resolution and JPEG picture size.
Setting up Region of Interest encoding for better quality.
Setting up scheduled recording and overwriting.
Managing storage, formatting HDD, and setting quotas.
Configuring FTP server for uploading captured pictures.
Setting overlay information for single captured pictures.
Customizing video OSD on the screen.
Settings for license plate recognition.
Settings for flash light control.
Setting general image parameters like saturation and sharpness.
Adjusting brightness, contrast, shutter speed for video.
Configuring shutter parameters for captured images.
Configuring IR Cut Filter modes for surveillance.
Configuring target capture and license plate recognition via video analysis.
Configuring device accounts and user permissions.
Steps to add a new user account with specific permissions.
Steps to modify network parameters of selected devices using SADP.
To Next Page