HIKVISION iDS-TCM203-A - Configuring TCP;IP Network Settings

User Manual of Network Traffic Camera revise
26
serial port. Device parameters can be configured by using software such as
HyperTerminal. The serial port parameters must be the same as the serial port
parameters of the camera.
• Transparent Channel: Connect a serial device directly to the camera. The
serial device will be controlled remotely by the computer through the
network.
Steps:
1. Go to Configuration > Device Configuration > System Configuration > Serial
Ports.
Figure 8-3 Serial Ports Settings
2. Configure the RS-485 and RS-232 parameters.
3. Click Save to save the settings.
8.4 Configuring TCP/IP Settings
Purpose:
TCP/IP settings must be properly configured before you operate the camera over
network.